Saf-T-Flo.com
 
 
TRADE SHOW REQUEST FOR PROPOSAL ENGINEER FEEDBACK OPERATOR FEEDBACK VISIT US ON
 
 
 
   
   
   
   
   
   
 

Installation Information for Non-Retractable Injection Quills

IQ Series: 150psi Rated (PVC/CPVC) • 1500psi Rated (Alloy)

 

PRECAUTIONS

Injection quills are designed to deliver a chemical solution feed to the interior of a pressurized water/process main. The following precautions should be taken to ensure proper and safe installation:

  • Become familiar with the components of the injector as listed below.
  • Verify that the injector being installed is compatible with the intended chemical feed.
  • Make sure to use the correct hex when using a wrench to install.
 
Retractable Sampling Probe - 150psi

INSTALLATION INSTRUCTIONS  

CAUTION: Take care not to over tighten PVC housings. Damage caused by over tightening voids warranty.
  • Apply Teflon thread tape or suitable sealant to the Main Connection Thread of the injector.
  • Thread the quill into the main using the lower Installation Hex (See Component 4) into the service tap.
  • Connect chemical feed line to inlet thread.
 

COMPONENTS

  1. Inlet Thread
  2. DO NOT use wrench on this hex
  3. Integrated Spring Loaded Ball Check Valve
  4. Installation Hex, use to tighten during install
  5. Main Connection Thread
  6. Solution Tube
 

SUGGESTED MAINTENANCE

  • Scaling and blockage can occur depending on the chemistry of the application and will vary.
  • The Solution Tube and Check Valve internals should be inspected regularly to ensure that it is impeding operation.
 

For installation questions and assistance contact customer service at 1-800-957-2383

 
  Home | Contact Us | Site Map © 2015 Saf-T-Flo Water Services, Inc. All rights reserved