Saf-T-Flo.com
 
 
TRADE SHOW REQUEST FOR PROPOSAL ENGINEER FEEDBACK OPERATOR FEEDBACK VISIT US ON
 
 
 
   
   
   
   
   
   
 

Installation Information for Non-Retractable Sampling Probes

Series EB-108 and EB-109 • 150psi Rated (PVC/CPVC) • 1500psi Rated (Alloy)

 

PRECAUTIONS

Sampling probes are designed to draw off a fluid sample from a pressurized water/process main. The following precautions should be taken to ensure proper and safe installation:

  • Become familiar with the components of the sampling probe as listed below.
  • Make sure to use the correct hex when using a wrench to install.
 
Non-Retractable Sampling Probe

INSTALLATION INSTRUCTIONS  

CAUTION: Take care not to over tighten PVC housings. Damage caused by over tightening voids warranty.
  • Apply Teflon thread tape or suitable sealant to the Main Connection Thread of the sampling probe.
  • Thread the sampling probe into the main using the lower Installation Hex (See Component 4) into the service tap.
  • Connect sampling line to outlet thread.
 

COMPONENTS

  1. Sample Valve Handle (SS Valve Option Shown)
  2. Sample Outlet
  3. Isolation Ball Valve
  4. Installation Hex, use to tighten during install
  5. Main Connection Thread
  6. Sample Quill
 

For installation questions and assistance contact customer service at 1-800-957-2383

 
  Home | Contact Us | Site Map © 2015 Saf-T-Flo Water Services, Inc. All rights reserved